Possible malfunction of mud pumps and troubleshooting methods

Picture of Lianhui Petro
Lianhui Petro

Specializes in innovative solutions for the petroleum industry.

All Posts
Latest Post

Mud pump problems & solutions

If a malfunction occurs during the operation of the mud pump, the cause should be found and eliminated in time, otherwise the machine parts will be damaged and the normal drilling operation will be affected.

Mud pump fluid end malfunction

Problems Reason Solutions
1.The pressure gauge shows a decrease in pressure, a decrease in displacement, or no discharge of mud at all 1. The water supply pipeline is not tightly sealed, causing air to enter the pump 2. The suction filter is blocked 1. Tighten the flange bolts of the water supply pipeline or replace the gasket 2. Stop the pump and remove the debris from the suction filter
2. Uneven discharge of liquid with fluctuating impacts, large swing amplitude of pressure gauge pointer, and whistling sound from water stop pipeline 1. A piston or a valve is severely worn or damaged 2. Air enters the pump cylinder 1. Replace the damaged piston and check if the valve is damaged or stuck. 2. Check if the water supply pipeline and valve cover are tight
3. There is a violent knocking sound at the mud pump liner 1. Loose piston nut 2. Loose Cylinder liner gland 3. Poor suction, causing water hammer 1. Tighten the piston nut 2. Tighten the Cylinder liner gland 3. Check the cause of poor suction
4.cylinder head, hydraulic cylinder and cylinder liner seals 1. Valve cover and cylinder head are not tightened 2. Sealing ring is damaged 1. Tighten the valve cover and cylinder head 2. Replace the sealing ring
5.The air bag cannot be filled with gas or leaks quickly after inflation 1. The inflation connector is blocked 2. The air bag capsule is broken 3. The needle valve is not tightly sealed 1. Clear debris from the connector 2. Replace the capsule 3. Repair or replace the needle valve
6.Diesel engine has a heavy load Discharge filter cartridge is clogged Remove the filter cartridge and clear out the debris
7.Abnormal friction in moving parts such as power end bearings and crossheads 1. The oil pipe or oil hole is blocked 2. The lubricating oil is too dirty or deteriorated 3. The rolling bearing is worn or damaged 4. Too much or too little lubricating oil 1. Clean the oil pipe and oil hole 2. Replace with new oil 3. Repair or replace bearings 4. Apply an appropriate amount of lubricating oil
8.There are abnormal noises at the power end, bearings, crosshead, etc. 1. The crosshead guide plate is severely worn 2. The bearing is worn 3. The guide plate is loose 4. There is water hammer at the hydraulic end 1. Adjust the gap or replace the worn guide plate 2. Replace the bearing 3. Tighten the guide plate bolts 4. Improve the suction performance

Note: In addition to the above estimated possible faults, if other abnormal phenomena are found, carefully find the cause according to the location of the fault, and the drilling pump can only operate normally after the cause is found and eliminated.

Facebook
Twitter
LinkedIn
Pinterest

Leave a Reply

Your email address will not be published. Required fields are marked *

Now Contact Us

Need expert petroleum solutions? Contact us now for reliable equipment and professional support. We're here to help you succeed. Reach out today!

Now Contact Us